01
HARDWARE VALIDATION
Every release is tested on original hardware. Original hardware behavior is treated as the reference baseline, and core functions are exercised repeatedly under normal and edge-case operating conditions.
02
REFERENCE BEHAVIOR & TIMING ANALYSIS
Timing-critical functions are measured against a defined original-hardware reference configuration. MIDI latency, jitter, clock stability and event placement are captured across repeated trials using documented test conditions.
Replacement operating systems and external control systems can introduce timing changes even when their new functionality works as intended. Hanamel therefore treats timing behavior as a measurable release criterion rather than an assumption.
03
REQUIREMENTS TRACEABILITY
Every release requirement is linked to a defined verification method and recorded test result. Changes to requirements, implementation or hardware interfaces are reviewed for their impact on existing behavior and validation coverage. A feature is not considered complete until its specified behavior has been verified on the target hardware.
04
REGRESSION TESTING
Existing functions are re-tested after changes. New features must not introduce timing regressions, corrupt sequence data or interfere with established hardware behavior. Affected verification procedures are repeated whenever validated behavior may have changed.
05
BOUNDARY & FAILURE TESTING
Interfaces and editing operations are tested at documented boundary conditions and under malformed, interrupted and unexpected input. Communication loss, invalid data, maximum and minimum values and interrupted operations are tested to verify predictable behavior and recovery without corruption of user data.
06
DATA INTEGRITY
Projects, sequences and edited events are tested through repeated save, load, transfer and edit cycles. Boundary values, dense sequences and unusual event combinations are included. Validation checks that operations preserve data not explicitly targeted by an edit.
07
STRESS & SOAK TESTING
Systems are tested under dense MIDI traffic, repeated editing and extended continuous operation. Long-duration soak tests are used to identify timing drift, communication failures, event loss and other faults that may only emerge after prolonged use.
08
CONFIGURATION CONTROL
Every release is tied to a uniquely identified software build, source revision, test configuration and supported hardware configuration. Development tools and build dependencies that can affect the released software are versioned or recorded so that validated builds remain reproducible.
09
DEFECT CONTROL
Failures discovered during validation are recorded, reproduced and tracked to resolution. Release-blocking defects must be resolved and the affected verification procedures repeated before a build can be approved for release.
10
RELEASE CANDIDATES
A release candidate is frozen and tested as a complete build before public release. Any change following validation requires the affected tests to be run again. Public releases must correspond to the configuration that completed release validation.